This heavier-duty foam saw, foam cutter is great for an upholstery shop or small manufacturer. It cuts 8" thick poly foam or foam rubber. Powerful 4.5 amp motor. Light-weight for easy handling. Cuts sharp turns with ease. Makes a clean cut without little pieces of foam to clean up. Foot plate rolls on your cutting table. Removable foot.
Use with silicone spray for the blade to easily slide through thicker foam.
Double blades: one moves, one is stationary. One-year factory warranty. This saw pays for itself in time saved. If you are outside of North America you'll need a 220–240 voltage converter-available at many hardware stores.
Foam saw that's great for upholstery shops and manufacturers. Has the durability of more expensive bosh foam saws.
Cuts polyfoam or foam rubber (do not use for styrofoam). Most foam you'll be cutting for an upholstery shop will be 2" to 5" thick. Hint: When cutting 1" or less foam make a little cut with your shears to keep the foam from pushing against the blade as you start out.
Light-weight for easy handling. One hand operation. Handle on top not underneath housing.
Cuts sharp turns with ease. Easily cut out ear cushions ("T" or "L" shaped). Many cushions are shaped in the back and dining room chair cushions are shaped all around usually.
Makes a clean cut without little pieces of foam to clean up. You can cut foam with a miter box saw or other methods but you may find little shavings of foam stuck on your fabric or jagged edges.
Foot plate rolls on your cutting table. Four tiny wheels move your saw forward and keep the blade straight.
Removable foot for freehand cutting. Comes with hex key.
Pays for itself in time saved. Cut a cushion out in about a minute.
One-Year Factory Warranty. Assembled and serviced in the USA. Manufacturer warranty will fix or replace defective saw.
Think Safety! You can be injured with this tool in the same way as any power saw. Keep your hands and fingers away from saw blade, make sure the foot plate is attatched properly, start cutting slowly for the first 1/2", always let the cutter cut at it's own speed and keep the base upright. Spray the blade and foot plate with DRY silicone for best results.
Comes fully assembled, no other parts to buy. Ready to roll!
